Setting Performance Measurement Conditions - Renesas M16C/64 User Manual

R0E530640MCU00 User's Manual
The contents displayed in this window are listed below.
Table 5.23 Columns and contents
Column
No
Condition
Run time
(h:m:s.ms.us.ns)
Count
Statistic
Max (h:m:s.ms.us.ns)
Min (h:m:s.ms.us.ns)
Average (h:m:s.ms.us.ns)

5.10.3 Setting Performance Measurement Conditions

In the Performance window, select a line of the section No. in which you want to set conditions and choose Set from the
context menu. The Performance Analysis Conditions dialog box will be displayed.
Figure 5.67 Performance Analysis Conditions dialog box
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 143 of 229
Numbers assigned to 1–8 measurement sections set in the Performance Analysis Conditions
dialog box.
Click Settings on the context menu to open the Performance Analysis Conditions dialog
box.
Indicated as Enable when measurement conditions are set in the Performance Analysis
Conditions dialog box.
Otherwise, indicated as Disable .
Cumulative execution time. It shows a cumulative time of measured execution time.
Shows the number of times measured.
Shows a ratio of cumulative execution time relative to Go–Break execution time.
[Ratio calculation formula]
(Cumulative execution time / Go–Break cumulative execution time) * 100
Maximum execution time per measurement performed
Minimum execution time per measurement performed
Average execution time per measurement performed
Description
5. Debugging Functions