Connecting To A 100-Pin 0.5Mm Pitch Foot Pattern - Renesas M16C/64 User Manual

R0E530640MCU00 User's Manual

2.9.2 Connecting to a 100-pin 0.5mm Pitch Foot Pattern

The following is a procedure of connecting to a 100-pin 0.5mm pitch foot pattern on the user system using the
R0E0100TNPFK00 (not included). For details on the R0E0100TNPFK00 (not included), refer to its user's manual.
(1) Attach the NQPACK100SD-ND included with the R0E0100TNPFK00 to the user system.
(2) Attach the YQPACK100SD included with the R0E0100TNPFK00 to the NQPACK100SD-ND and secure it with the YQ-
GUIDEs.
(3) Attach the R0E0100TNPFK00 to the YQPACK100SD.
(4) Attach the CN2 side of the R0E0100TNPFK00 to the CN2 side of the flexible cable.
(5) Attach the CN1 side of the R0E0100TNPFK00 to the CN1 side of the flexible cable.
These corners
are not round.
Figure 2.12 Connecting to a 100-pin 0.5mm pitch foot pattern
Notes on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
The connectors of the R0E0100TNPFK00 are guaranteed for only 50 insertion/removal iterations.
For purchasing the HQPACK100SD, contact the following:
Tokyo Eletech Corporation
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 35 of 229
(4)
*
No. 1 pin
: These four products are
*
available in one package.
http://www.tetc.co.jp/e_index.htm
(5)
R0E0100TNPFK00
(3)
YQ-GUIDE (×4)
YQPACK100SD
(2)
NQPACK100SD-ND
(1)
100-pin 0.5mm pitch
(PLQP0100KB-A) foot pattern
User system
CAUTION
Evaluation with
actual MCU
HQPACK100SD
(not included)
FLASH version
MCU, etc.
2. Setup