Error At Debugger Startup - Renesas M16C/64 User Manual

R0E530640MCU00 User's Manual

6.3 Error at Debugger Startup

(1) When the LEDs of the E100 Do Not Display Normally
Table 6.1 Checkpoints of errors when the LEDs do not display normally
Error
SAFE LED remains lit.
SAFE LED does not light up.
Target Status POWER LED
does not light up.
Target Status RESET LED does
not go out.
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 213 of 229
Connection to
the user system
- Check that the power cable is connected.
See "2.4 Connecting the Host Machine" (page 26).
- Recheck the connection between the E100 and this product.
See "2.3 Connecting/Disconnecting the MCU Unit to/from the E100
Emulator Main Unit" (page 25).
Connected Check that power (Vcc and GND) is properly supplied to the user
system and that the user system is properly grounded.
Connected (1) Check that the reset pin of the user system is pulled up.
(2) When using the emulator without the user system, check to see
if a converter board is disconnected from the emulator.
6. Troubleshooting (Action on Error)
Checkpoint