Table of Contents
Advertisement
R0E530640MCU00 User's Manual
2. Setup
This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.
2.1 Flowchart of Starting Up the Emulator
The procedure for starting up the emulator is shown in Figures 2.1 and 2.2. For details, refer to each section hereafter. If the
emulator does not start up normally, refer to "6. Troubleshooting (Action on Error)" (page 211).
1
Check the package components.
2
User registration
3
Install the included software, etc.
Connect the MCU unit to the E100 main
4
unit.
5
Connect the host machine.
6
Connect the emulator power supply.
7
Turn on the power supply.
8
Check the LED display of the emulator.
Try to use the emulator debugger according
9
to the tutorial.
Create a project in the High-performance
10
Embedded Workshop.
Start up the emulator debugger from the
11
High-performance Embedded Workshop.
12
Set up the target MCU and system.
13
Execute self-check
Figure 2.1 Flowchart of starting up the emulator (For the first time)
REJ10J1733-0100 Rev.1.00 Apr. 01, 2008
Page 22 of 229
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
Refer to "1.1 Package Components" (page 16).
Refer to "User Registration" (page 14).
Install them from the included CD-ROM.
Refer to "2.3 Connecting/Disconnecting the MCU Unit to/from the
E100 Emulator Main Unit" (page 25)
Connect the USB interface connector of the emulator and the USB
port of the host machine.
Connect an emulator power supply to the power connector.
Turn ON the power to the emulator.
Check that the system status LED is lighting. When the user system
is not connected, the POWER LED does not light up.
When using the emulator debugger for the first time, try to use the
emulator functions, referring to "3. Tutorial" (page 36).
If the emulator debugger does not start, follow steps 10 through 13
in this chart to perform a self-check.
Start up the High-performance Embedded Workshop and create a
project by following "4. Preparing to Debug" (page 67).
Start up the High-performance Embedded Workshop to launch the
emulator debugger by following "4. Preparing to Debug" (page 67).
Set Device Setting dialog box of the emulator debugger and check
"Start booting up on successful completion of self checking" by
following "4. Preparing to Debug" (page 67).
2. Setup
Advertisement
Table of Contents
