Add User Beam - Veripos LD6 Operation Manual

Procedure Title: LD6 Operations Manual (B Variant)
File Ref.: AB-V-MA-00589
5.4

ADD USER BEAM

The 'User Beam' facility is provided for the manual entry of new satellite beams to receive
VERIPOS corrections.
Use this channel for your work region ONLY when advised by VERIPOS.
Go to LBand/ Config/ Beams User Beams/ Edit
Use the Arrow buttons to Select from pre-set names, 'User 1-3'.
Where a new beam frequency needs to be entered:
On the User beam to edit (User1 – 3), touch Edit and use the Arrow buttons / Next to
enter the frequency and Bitrate (normally 1200).
Touch Update to enter the frequency. Finally navigate to Home / LBAND /Config /
Beams and Enable the User beam as required.
Rev No: A4 Page 72