Veripos LD6 Operation Manual page 52

Procedure Title: LD6 Operations Manual (B Variant)
File Ref.: AB-V-MA-00589
2.9.4.1 LD6 LAN Ports
There are two RJ45 LAN ports mounted under the power connector on the extreme left of
the rear panel labelled "Ethernet".
The upper port is LAN1, the lower port is LAN2.
2.9.4.2 Network Status
Touch Settings/ Network/ Status button to display the current settings of the ports.
The Up/Down arrows may be used to switch between LAN1 and LAN2. The following
information is displayed:

Name

Addr

IP

Mode
If an IP is assigned from the server, it is displayed followed by "(auto)".
If no IP is assigned from the server, the LAN port falls back to the static IP. The static IP is
displayed followed by "(fallback)".
Rev No: A4
LAN1 or LAN2
(Up = Connected, Down = Disconnected)
MAC address of network interface card
Current IP address of LAN port
Static or DHCP
Static = Fixed IP which can be set by user
DHCP = Dynamic IP, normally assigned by a DHCP server
Page 52