Procedure Title:
LD6 Operations Manual (B Variant)
File Ref.:
AB-V-MA-00589
2.4
LD6 START-UP
Confirm the LD6 has been correctly installed.
Where required refer to the LD6 Installation Manual and the Antenna & Coaxial Cable
Installation Guide.
These documents are provided with the unit or may be downloaded in .pdf format from the
VERIPOS online support system (VOSS) at:
http://help.veripos.com
Plug in power to the rear of the unit. Turn on power switch.
Wait a few minutes while a self-test is performed.
Following successful test you will see the main or home screen.
The LD6 is disabled when first started. Before a beam is selected and the unit is enabled
the LBAND icon will be red.
If there is a problem refer to the Troubleshooting chapter in this manual.
Key
1. LD6 unit ID
2. S – L-BAND beam Synch Green = yes, Red = not synched with beam
3. E – VERIPOS corrections Green = enabled Red = not enabled
4. L-BAND signal strength indicator. These signal strength bars have three states:
Rev No:
A4
LD6 Home Screen
Page 17