Veripos LD6 Operation Manual page 22

Procedure Title: LD6 Operations Manual (B Variant)
File Ref.: AB-V-MA-00589
If "No Beam" or the incorrect regional beam is shown, select Edit and select the beam for
your work region.
Use the up/down on-screen arrows to highlight and select the beam required.
When the required beam name is highlighted, touch the Enable button, and then Close.
Return to the LD6 Home page.
The 'S' (Sync) icon will turn from red to green when a usable beam is correctly selected
and signals are received.
If the beam has been changed, L-Band beam status can be checked as described in
Section 2.5.1.
2.5.2.2 User Beams
User Beams should only be selected under direction from VERIPOS.
User Beams are not used during normal LD6 operation. Custom entry of a user Beam is
provided to allow the user to manually configure a Beam frequency and bit rate for
reception of VERIPOS L-BAND corrections.
Full instructions regarding User Beam entry can be found in Section 4 of this manual.
Rev No: A4 Page 22