Display Config - Veripos LD6 Operation Manual

Procedure Title: LD6 Operations Manual (B Variant)
File Ref.: AB-V-MA-00589

2.10.5 Display Config

2.10.5.1
The Display Select menu is only relevant when a touch-screen enabled external monitor is
connected to the LD6. This setting allows the correct drivers to be installed. The
supported touch-screen monitors are Hatteland and Norco. For use with other monitors it
is recommended to contact VERIPOS for further advice.
Select the appropriate drivers for the monitor in use using the Up/Down arrows then press
Enter.
After editing the Display select settings, a reboot will be required to ensure settings are
applied resulting in a temporary loss of positioning.
2.10.5.2
When an external monitor is attached, the external monitor effectively becomes an
extension of The LD6 screen. The LD6 screen is always defined as screen 1 and the
external screen is screen 2.
A mouse can be used to control both screen 1 and screen 2. To move the mouse from the
LD6 screen on to the external monitor, drag the mouse to the right.
To move the mouse from the external monitor to the LD6 screen, drag the mouse to the top
left of the monitor.
The screen layout used is shown below:
Rev No: A4
Display Select
Dual Monitor Screen Layout
Page 56