Veripos LD6 Operation Manual page 18

Procedure Title: LD6 Operations Manual (B Variant)
File Ref.: AB-V-MA-00589
5. Touch screen buttons to access L-BAND card, GNSS card, optional MF (Beacon
SBX receiver) and UHF ADL cards, information and controls. Buttons provide
access to each receiver (as fitted).
6. LD6 time display (UTC)
7. Buttons in red indicates the cards have configuration or fault condition and are not
working to correct limits.
8. Actions – Shut down, Log Off, Reboot, Factory Reset or LD6 Screen calibration of
screens 1 and 2, Launch Apps.
9. Solutions – Displays LD6 solution status.
10. Settings –Set up of position output ports, network configuration and provides
general status information.
The above Home Screen shows an enabled LD6 touch screen. Four of the six rear bays
are equipped with receiver cards. Two bays are for future use.
The home page of the LD6 touch screen displays the Unit ID number (top left).
The time is shown in Coordinated Universal Time (UTC), 24 hour format (top right).
Each of the four upper touch screen buttons correspond to a receiver or card housed in
bays accessed from the rear of the LD6. LD6 units may not have all cards fitted.
The LD6 Home Screen will only display receiver module icons which are installed.
Configuration of each installed and working receiver card is done using the touch screen
front panel. Select the corresponding on screen button.
Rev No: A4
No. of Signal Strength Bars
0
1
2
3
Signal Strength (dB/Hz)
0 (No Sync)
<32.5
32.5 to 36.5
>36.5
Page 18