Enable For Veripos Corrections; Module Reboot - L-Band; Factory Reset - L-Band; Hints - L-Band - Veripos LD6 Operation Manual

Procedure Title: LD6 Operations Manual (B Variant)
File Ref.: AB-V-MA-00589

2.5.5 Enable for VERIPOS Corrections

Download a Service Notification Form from
contacting Helpdesk for an enable access code.
Tel. +44 1224 965900
Go to the LD6 Access Code page LBAND/ Access Info.
Contact the VERIPOS Helpdesk to request the unit is enabled and quote:

Unit ID

Service Access Licence (SAL) number

Provide details of the type of Service(s) you require, e.g. Standard, Standard²,
Ultra, Ultra², Apex, Apex² and DP Orion
Only when the L-BAND receiver has Sync (S) to a valid beam will it display access code
information or allow you to enable/disable the LD6.
The Helpdesk will enable the requested services for the LD6 over the air.
If after requesting the LD6 to be enabled the Access Info page still shows Disabled,
confirm the LD6 still has Sync (S on the Home screen) and contact the VERIPOS
Helpdesk. They can then resend the enable command over the air.
2.5.6 Module Reboot – L-Band
Access this option via Home/ LBAND/ Module Reboot. Pressing Module Reboot will
reboot the L-Band card only, the LD6 will not reboot.
2.5.7 Factory Reset – L-Band
Use only under instruction from a VERIPOS engineer.
2.5.8 Hints – L-Band
Provides general guidance information where available.
Rev No: A4
http://help.veripos.com
Email: helpdesk@veripos.com
Page 26
and use this when