Veripos LD6 Operation Manual page 53

Procedure Title: LD6 Operations Manual (B Variant)
File Ref.: AB-V-MA-00589
2.9.4.3 Network Configuration
From the Network menu touch the Config button to open the configuration page.
Use the Up/Down arrows to switch between LAN1 and LAN2. The display shows the port
name, current IP and current mode.
To change the current configuration, touch the Next button.
Use the Up/Down arrows to change the mode if required, then touch the Next button to
move to the next setting. It is necessary to cycle through all four pages in order to reach
the "Finish" button which is used to accept the changes.
These pages allow the user to set:
2.9.4.4 LAN Default Settings
The LAN default settings are as follows:
Mode: STATIC
Static IP (LAN1):
Static IP (LAN2):
Subnet Mask:
Gateway Address (LAN1):
Gateway Address (LAN2)
2.9.4.5 LAN Connection to Verify QC
Ethernet is the preferred method of interfacing to Verify QC. All interfaces can be
supported using a single CAT5e or CAT6 network cable.
Cable runs typically encountered on vessels fall within the Ethernet specification. This
contrasts to using RS232 where multiple cables are required and longer runs may pose
problems when high baud rates are required [e.g. for GNSS Raw data].
Rev No: A4
Set
Mode
Static Address
Subnet Mask
Gateway Address
192.168.002.002
192.168.003.003
255.255.255.000
192.168.002.001
192.168.003.001
Description
Choose between Static or DHCP –
Veripos recommend use of Static
To Set Static / Fallback address
To set the Subnet Mask info
Where required – Use Finish button
to confirm changes.
Page 53