Module Reboot - Uhf; Factory Reset - Uhf; Hints - Uhf - Veripos LD6 Operation Manual

Procedure Title: LD6 Operations Manual (B Variant)
File Ref.: AB-V-MA-00589
2.8.2.2 Link Speed, FEC and Sensitivity
Amend the link speed from Home/ UHF/ Config/ Yes/ Tune/ Link Speed.
Use the onscreen controls to select:

Select Link Speed of 4800 or 9600 bps.

Forward Error Coding (FEC) on or off

Switch Sensitivity between Low, Medium and High.
When finished entering information return to the Status section (Home/ UHF/ Status) to
review the RTCM data delay and channel settings applied.

2.8.3 Module Reboot - UHF

The module reboot will reboot the UHF module without disruption to the other receiver
cards.
Only use when the UHF module is not operating correctly.

2.8.4 Factory Reset - UHF

This function should only be used under direction of a VERIPOS representative.
2.8.5 Hints – UHF
Provides advice where available.
Rev No: A4 Page 44