Do's And Don'ts For Ld6 - Veripos LD6 Operation Manual

Procedure Title: LD6 Operations Manual (B Variant)
File Ref.: AB-V-MA-00589

DO'S AND DON'TS FOR LD6

2.2
DO's

Do use Shutdown control (in the Actions menu) for the LD6 BEFORE turning off
the power. Wait until the LD6 screen is blank before disconnecting power.

Do take care not to obstruct the side ventilation panels for the fan assisted cooling
tunnel.

Do only connect the LAN Crossover network adapter (where required) to an LD6
LAN port. The adapter wiring is not compatible with serial COM ports.

Do connect external monitor (where required) to the rear VGA connector prior to
switching on the LD6. If a monitor is connected after LD6 is switched on, it will not
be detected.
DON'TS

Don't load software onto the LD6 not issued from VERIPOS e.g. as part of the LD6
build. Doing so could seriously compromise system performance.

Don't insert USB memory device unless first scanned with up to date virus scanning
software.

Don't activate the pin reset buttons on the rear of the unit unless directed by a
VERIPOS representative.

Don't remove the QC dongle when using the Verify QC software is running on-
board the LD6.

Don't use a pen or any other sharp object to operate the touch screen as this could
cause damage.
Rev No: A4 Page 14