Monitoring An Audio Source - pro bel TX 410 Operator's Manual

Pro-Bel
8.1

Monitoring an audio source

To monitor an audio source using either MONITOR 1 or MONITOR 2:
1
Press either <PGM>, <PST>, or <AUX> for monitoring a source, or
press <TX> for return monitoring.
2
If the audio for a different source is to be monitored on the selected
bus, press a different source button.
Caution: Pressing a PGM button changes the programme on-air.
3
Adjust the volume of the monitor output by using the level control
and/or the <CUT> or <DIM> buttons.
Turning the control clockwise increases volume.
Pressing <CUT> cuts the volume completely and lights the button.
Pressing it again brings it back at full volume, as set by the
control.
Pressing <DIM> lowers the volume and lights the button. Pressing
it again brings it back at full volume, as set by the control
Note: If the buttons are configured to be cut left and cut right
then when <CUT> is lit, the left is cut and when <DIM> is lit the
right is cut. These act independently and one or both can be on/off
at any time.
HU-TX 410OG
TX 410 operators guide
47