pro bel TX 410 Operator's Manual page 71

Pro-Bel
2
To select a different wipe pattern, press the 'soft' button that
corresponds to the wipe pattern required.
The new wipe pattern selected is shown in the lower right corner
of the screen.
3
To set the direction of wipe, press the 'soft' button to toggle
between NORM (normal – Forward) and REV (reverse).
4
To set softness state, press the 'soft' button to toggle between SOFT
ON, to turn softness ON, or SOFT OFF to turn it OFF.
If OFF is selected the wipe setup is complete. Press <HOME> to
display the home screen.
5
To modify the edge softness, turn either of the shaft encoders below
the display. Turning it clockwise increases the softness, while anti-
clockwise decreases it.
Softness of 0% has the same effect as turning the softness state to
OFF. Press <HOME> to display the home screen.
HU-TX 410OG
TX 410 operators guide
71