Pro-Bel
6.2
Previewing an audio-over
It is possible to pre-listen to an audio-over before taking it to air, or
when setting the PGM and OVER levels.
1
Select <PST> to the loudspeakers (see chapter 8).
2
Press and hold down the required audio-over source.
3
The PST audio monitor will switch to a mix of the audio-over and
the source selected on the PST bus. The <OVER> control and the
<PGM> control can be adjusted to the required setting which will
be stored for each over source (section 6.3).
HU-TX 410OG
TX 410 operators guide
39