Manual Transitions - pro bel TX 410 Operator's Manual

Pro-Bel

3 Manual transitions

This chapter describes how to set up the next transition manually and
take it to air.
If the TX 410 is connected to a presentation automation system, for
example, Pro-Bel's Compass system, the programme can be setup and
taken to air automatically.
In normal operation transitions are made by:
1 Selecting the video and audio sources (see chapter 2). These are
first selected on the preset (PST) bus.
2 Selecting the transition type and speed by pressing white buttons
in the bottom left hand corner of the panel.
3 If desired, selecting one or both DSKs (see chapter 4) and an
audio-over (see chapter 6) to follow the transition.
4 Taking the transition by using the red Take buttons along the lower
edge of the panel.
HU-TX 410OG
TX 410 operators guide
17