Temporarily Restoring Unity Gain - pro bel TX 410 Operator's Manual

TX 410 operators guide

15.3 Temporarily restoring unity gain

If the gain of a source has previously been set and is not unity, then the
level setting is stored and recalled when the source is selected again on
any of the busses. If a selected source is not at unity gain then the
small, unmarked, button at the right-hand end of the row the source is
selected on will be illuminated.
1
Press the small button at the right hand end of the bus row on
which the source is selected.
The button light goes out and the source is at unity gain.
NOTE: Once a source has been temporarily restored to unity gain, it
remains at unity until the source is reselected. After being reselected it
will be restored to the saved gain value. Any changes made on the audio
(gain) setup screen will not affect the source once it has been
temporarily set to unity until it is reselected.
Performing this action on a source via the preset row will carry the
temporary unity selection to the PGM bus after a PST/PGM transition.
80
Pro-Bel
Issue 2