Selecting Sources On Preset (Pst) - pro bel TX 410 Operator's Manual

TX 410 operators guide
3.1

Selecting sources on preset (PST)

It is preferred practice to set up the transition on the preset (PST) bus.
The selection can be either select married video/audio from the same
source (see Step1 below), or video and audio from different sources (see
Steps 2 and 3).
At the bottom left of the panel, the <VIDEO> and <AUDIO> buttons are
used for setting up video/audio breakaway.
1
To select married video/audio, first ensure that neither the
<VIDEO> or <AUDIO> buttons are lit, and then select the required
source button from the PST bus.
The PST source button is lit at full brightness.
2
To select only a new video preset, select the video by pressing
<VIDEO> to light it, and then press the required source button on
the PST bus.
The newly selected source button is lit at full brightness indicating
video only selection. The original source button is lit at half
brightness, indicating audio only.
3
To select only a new audio preset, press <AUDIO> to light it and
then press the source button on PST from which you want the audio.
The newly selected source button is lit at half brightness indicating
audio only selection. The original source button is lit at full
brightness, indicating video only.
18
Pro-Bel
Issue 2