Selecting A Dve Sequence; Previewing A Dve Sequence - pro bel TX 410 Operator's Manual

Pro-Bel
5.1

Selecting a DVE sequence

Pressing the <DVE SEQ n> push button selects the corresponding
sequence (numbered 'n') from the DVE. The selected sequence button
remains highlighted.
It is not possible to select a new sequence if the DVE is either on air;
indicated by the <DVE> button being lit, or being previewed; indicated
by the <PRVW SEQ> 'soft' button being lit.
1
From the home screen, press the <DVE SEQ n> button
The first page of the DVE selection screen is displayed.
2
To select a sequence press the <PAGE> button until the required
sequence number is visible. Select the sequence number.
The selected sequence will be highlighted. To return to the home
page, press <HOME>. The newly selected sequence will be shown
in the <DVE SEQ n> button.
5.2

Previewing a DVE sequence

Pressing the <PRVW SEQ> button previews the selected DVE sequence.
While the sequence is being previewed the preview push button remains
highlighted. It is not possible to preview a sequence whilst another
move is activated or if the DVE is currently on air.
1
Select the sequence to preview (refer to section 5.1).
2
Press the <PRVW SEQ> button
The <PRVW SEQ> button will light, and the DVE sequence is activated.
This can be viewed at the DVE output, but does not appear on the system
PGM output. The <PRVW SEQ> button will remain lit until pressed again
to cancel the preview.
HU-TX 410OG
TX 410 operators guide
35