Taking A 'Pre-Rolled' Machine - pro bel TX 410 Operator's Manual

TX 410 operators guide
control when the next transition will be made. Deselecting the <HOLD>
button then pressing the <PRE-ROLL/TAKE> button re-starts the
schedule.
3.4

Taking a 'pre-rolled' machine

1
Select the required source to the PST bus. To take the transition in
one step, including pre-rolling the machine, press <PRE-ROLL &
TAKE>.
The machine is started. The red PGM source buttons light after the
pre-configured ROLL time, corresponding to the sources pre-
selected on PST. The pre-roll time is displayed in the window above
the <PRE-ROLL & TAKE> button. The transition is made using the
type and speed shown by the lit transition setup buttons.
2
To abort the transition once a pre-roll has started, press the
<ABORT> button next to the countdown timer.
The transition is aborted and the pre-roll countdown timer resets.
The PGM and PST sources remain unchanged.
24
Pro-Bel
Issue 2