Selecting The Transition Type And Rate - pro bel TX 410 Operator's Manual

Pro-Bel
Note: The level select buttons, <AUDIO> and <VIDEO>, can be
configured to either manually or automatically cancel after selection on
the PST bus. Refer to the technical manual for details.
3.2

Selecting the transition type and rate

The type and rate of a transition are selected by pressing buttons in the
lower left hand corner of the panel. The transition rate buttons are
configured via the touchscreen. For details refer to the technical
manual.
Setting up the transition
The type and speed of transition are selected by pressing the
appropriate transition type white button in the bottom row of the lower
console.
The available transition types are indicated by the buttons shown below
(from left to right):
<CUT> Cut directly to the selected sources without fading or using a
wipe.
<V FADE> Fade out the current programme to black and then fade in
the new programme.
<TAKE/FADE UP> Cut the current programme and then fade in the
new programme.
<FADE DOWN/TAKE> Fade out the current programme and then cut in
the new programme.
<MIX> Fade out the current programme and at the same time fade in
the new programme.
HU-TX 410OG
CUT CUT CUT
TX 410 operators guide
19