Alarms - Eaton i-on16 Administrator's And User Manual

i-on16

2. Alarms

The table below shows the different kinds of alarms possible.
Type of
Alarm
Intruder Loud warbling
tone from siren.
Fire Pulsing tone
from siren.
Hold Up Loud warbling
tone from siren
Tamper Loud warbling
tone from siren
Technical Quiet beeping
once per second
from keypads.
Fault Quiet beeping
once per second
from keypads.
Signal
(see note)
Normal alarm or entry route zone
activated when system is set.
24 hour zone activated at any time.
Fire zone activated at any time.
HUA zone or radio Hold Up Alarm
transmitter activated at any time.
(The installer must enable this feature on
your system.)
Some part of the alarm system has been
opened (tampered with).
An alarm system cable has been cut or
shorted.
An incorrect user code has been entered
too many times.
Technical alarm zone activated at any
time.
A system fault detected by the control
unit, for example, mains failure, or
communications line fault. See page 17.
Started by:
Pressed on keypad.
Page 13