If The System Will Not Set By Remote Control - Eaton i-on16 Administrator's And User Manual

3. Setting and Unsetting
Make sure the system is idle, and that you can hear the warning tones from
the sounders.
1. Press the appropriate button on the remote control, either full set (A)
or part set (B) (see Figure 8).
Figure 8. Remote Control Button Functions.
The keypad sounds the exit warning tone.
2. Complete setting using the method programmed by the Installer (see
"3. Finishing Setting" on page 20).
Unsetting
1. Enter by the designated entry door.
2. Press on your remote control.
The system unsets. At this point the system displays the standby screen.
Note: Your Master User may have programmed the control unit so that you
cannot unset the alarm system using a remote control. See page 77.
However, if the entry timer has started then you can still use your
remote control to unset the system.

If The System Will Not Set by Remote Control

If one of the detectors is still active when you try to set the system then you
will not hear the exit warning tone.
What happens next depends on how the installer has set up your system.
a) Try pressing A once more on your remote control. If the installer has
programmed the system to do so then it will carry on and set, omitting
the active detector.
b) If the system will not set on the second press of button A then you will
have to go to the keypad and set the system from there.
Page 28
Transmit LED
Full Set
Part Set
B
Unset
A
(Programmable)
i-on16