Eaton i-on16 Administrator's And User Manual page 65

i-on16
The display asks you to press both
buttons on the radio HUA you wish
to test.
If there are no radio HUAs
available the display briefly shows:
8. Press and hold down both buttons
on the Hold Up Alarm you wish to
test (you should hold the buttons
down until the transmit LED on the
radio HUA flashes).
If your type of Hold Up Alarm has a
lock button, make sure you unlock
the button before the test.
The keypad gives a double "beep"
confirmation tone.
The top line of the display shows
he user the radio HUA is allocated
to. (If the user has a name
programmed then it will appear in
place of the user number.)
The bottom line of the display
shows the strength of the signal
received by the system from the
radio HUA. If the signal strength is
less than 4 you should contact your
installer.
a) Press and hold the buttons on any
other HUA that you wish to test.
Each time you activate a HUA the
keypad gives a double "beep"
confirmation tone.
The display shows information for
any radio HUA allocated to a user
of the system, for example:
Press  to end the test.
9.
4. Administration










Page 59