Redirecting Speech Messages - Eaton i-on16 Administrator's And User Manual

i-on16
Once you have carried out this process, then a user with a Fob-2W-4B can
start a HUA by pressing any two diagonally opposite buttons on their fob at
the same time.

Redirecting Speech Messages

Note: This option is available only if you have the a speech dialler module
fitted inside the control unit and it has been programmed by the
installer. You can use the About menu to check if you have a
communication module fitted, see page 82.
If you need to re-direct speech messages to new telephone numbers then:
1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Press  until you see:.
4.
Press .
5.
Press  until the display shows:
6.
Press .
7.
Press  until the display shows the
8.
telephone number that you wish to
change, for example:
Press .
9.
The display shows the current
phone number, for example:
10. Key in the new phone number.
If necessary, press  to move the
cursor left, or  to move the cursor
to the right. Press  to remove
digits to the left of the cursor.
4. Administration




















Page 79