Controls; Displays - Eaton i-on16 Administrator's And User Manual

1 Introduction

Controls:

A Full Sets the system. (All detectors in use.)
B, C Part Set the system. (Some of the detectors in use.)
and D
Unsets the system.

In menus: scroll up. In text editing: move cursor left

In menus: scroll down. In text editing: move cursor right.
If the bottom line of the display shows a ">" at the right then pressing this key

selects the submenu named on that line.
If the bottom line of the display shows "On" "Off" "Yes" "No" "I" (for
include) "O" (for omit) then pressing this key changes the value to
its opposite.
When editing names moves the cursor to the right.

Deletes characters when editing names.

Press this key to confirm a decision and save any changes.

a) Moves the display to a higher level of the menu.
b) Press this key to abandon your decision when the display shows
"Are you sure Y/N?"
Press this key to gain access to the Menu.
1 to 0, Used to key in access codes. Can also be used to key in text for
*, # names, and telephone numbers.
# Used when keying in text: press to change between capitals or
small letters.
Press both these keys at the same time to start a Hold Up Alarm.
(The Installer must enable this feature.)

Displays

The LCD display shows messages and prompts to help guide you through
setting, unsetting, resetting and programming the system.
Page 6
i-on16