Eaton i-on16 Administrator's And User Manual page 72

4. Administration
13. Press 
The display shows:
14. Press .
There are two options to "Latched".
"Yes". The output stays on until a
user deliberately turns it off. In
addition, you can program the
output to come on and go off at
fixed times (see the next section).
"No". The output goes on when a
user turns it on, but then goes off
again after a set time. You can
program the length of time the
output remains on.
15. Press  or  to select the option
you wish to use.
For example:
16. Press  to confirm your choice.
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
To Program Duration Times for non-Latched Outputs
First make sure that the output you wish to use is programmed as
Latched=No (see steps 1 to 16 starting on page 64).
17. Press  until the display shows:
18. Press .
The display shows the length of
time the output will stay turned on
(in seconds).
19. Key in the number of seconds that
you want the output to stay on. The
maximum is 999s.
Page 66














i-on16