If You Cannot Reset The System - Eaton i-on16 Administrator's And User Manual

i-on16
If you return to the control unit after the
sirens have stopped and key in your
access code then the red LEDs around
the navigation keys glow to tell you that
an alarm has occurred.
Press  or  and key in your user
code to see the name of the zone (if the
installer has programmed one), for
example:
Press  to restore the display to
normal.
If you wish to see any other zones that were triggered during the alarm,
look in the log (see page 48).

If You Cannot Reset the System

Your system may be programmed so that it has to be reset by an installer
after an alarm.
If the top line of the display
shows:
Then contact your alarm
installer.
The installer will either come to your site and reset the system for you,
or, if the system has a suitable communicator fitted, send a signal to the
control unit to allow you to reset the system.
Remote Reset (aka Anti-Code Reset)
The installer may have programmed your system so that they can give you
a special code to reset the alarm system.
The screen will tell you where the alarm
occurred, for example:








2. Alarms
Page 15