Disconnecting From The Cpdlc System; Enabling/Disabling Data Mode; Cpdlc System Failure - Garmin G1000 Manual

AUDIO PANEL AND CNS

DISCONNECTING FROM THE CPDLC SYSTEM

After successfully initiating a CPDLC session, the LOGOFF Softkey becomes available.
To Log-off the CPDLC System:
1) From the MFD, select the CPDLC Softkey.
2) Select the LOGOFF Softkey.

ENABLING/DISABLING DATA MODE

The Link 2000+ will only operate when the GDR 66 is in data mode. There are times when it may be
desirable to enable or disable the VDL (VHF Data Link) connection.
To enable/disable data mode on the GDR 66:
1) From the MFD, select the CPDLC Softkey.
2) Press the Menu Key to display the page menu.
3) Turn the small FMS Knob to highlight 'Disable Data Mode' or 'Enable Data Mode' and press the ENT Key.

CPDLC SYSTEM FAILURE

A red "X" over the Status Window on the CPDLC Messages Page indicates that the system is unavailable. The
failure or loss of connectivity can result from a power loss, a data path loss, or improper configuration. Refer to
the system messages in the Appendices for additional information describing the source of the failure.
138
Figure 4-27 CPDLC Failure
Garmin G1000 Pilot's Guide for the Socata TBM 850/900 190-00709-05 Rev. D