Miscellaneous Message Advisories - Garmin G1000 Manual

APPENDIX A
GTS 820 MESSAGE ADVISORIES
Message
GTS CONFIG – GTS config error.
Config service req'd.
MANIFEST – GTS software
mismatch, communication halted.
GCU 475 MESSAGE ADVISORIES
Message
GCU CNFG – GCU Config error.
Config service req'd.
GCU FAIL – GCU is inoperative.
MANIFEST – GCU software mismatch,
communication halted.
GCU KEYSTK – GCU [key name] Key
is stuck.
GMC 710 MESSAGE ADVISORIES
Message
GMC CONFIG – GMC Config error.
Config service req'd.
GMC FAIL – GMC is inoperative.
MANIFEST – GMC software
mismatch. Communication halted.
GMC KEYSTK – GMC [key name] Key
is stuck.

MISCELLANEOUS MESSAGE ADVISORIES

Message
FPL WPT LOCK – Flight plan waypoint
is locked.
FPL WPT MOVE – Flight plan
waypoint moved.
TIMER EXPIRD – Timer has expired.
668
Comments
The GTS and GDU have incompatible configurations. This alert is also set when the GTS
has an invalid mode S address configured or the mode S address does not match both
XPDR mode S addresses.
The GTS has incorrect software installed. The G1000 system should be serviced.
Comments
GCU 475 configuration settings do not match those of backup configuration memory.
The G1000 system should be serviced.
A failure has been detected in the GCU 475. The GCU 475 is unavailable.
The GCU 475 has incorrect software installed. The G1000 system should be serviced.
A key is stuck on the GCU 475 bezel. Attempt to free the stuck key by pressing it
several times. The G1000 system should be serviced if the problem persists.
Comments
Error in the configuration of the GMC 710.
A failure has been detected in the GMC 710. The GMC 710 is unavailable.
The GMC 710 has incorrect software installed. The G1000 system should be serviced.
A key is stuck on the GMC 710 bezel. Attempt to free the stuck key by pressing it
several times. The G1000 system should be serviced if the problem persists.
Comments
Upon power-up, the G1000 system detects that a stored flight plan waypoint is
locked. This occurs when an navigation database update eliminates an obsolete
waypoint. The flight plan cannot find the specified waypoint and flags this message.
This can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
Or
update the waypoint name/identifier to reflect the new information.
The system has detected that a waypoint coordinate has changed due to a new
navigation database update. Verify that stored flight plans contain correct waypoint
locations.
The system notifies the pilot that the timer has expired.
Garmin G1000 Pilot's Guide for the Socata TBM 850/900 190-00709-05 Rev. D