Garmin G1000 Manual page 38

SYSTEM OVERVIEW
Level 1 Level 2
BRG2
ALT UNIT
STD BARO
OBS
CDI
ADF/DME
XPDR
XPDR1
XPDR2
STBY
ON
ALT
GND
VFR
CODE
IDENT
TMR/REF
NRST
MSG
24
Level 3
360 HSI Displays the HSI in a 360 degree view
ARC HSI Displays the HSI as an arc
Cycles the Bearing 2 Information Window through NAV2 or GPS
waypoint identifier and GPS-derived distance information, and
ADF/frequency.
Displays softkeys for setting the altimeter and BARO settings to
metric units
METERS When enabled, displays altimeter in meters
IN Select to display the BARO setting as inches of mercury
HPA Select to display the BARO setting as hectopacals
Sets barometric pressure to 29.92 in Hg (1013 hPa if metric units
are selected)
Selects OBS mode on the CDI when navigating by GPS (only
available with active leg)
Cycles through GPS, VOR1, and VOR2 navigation modes on the
CDI
Displays the ADF/DME Tuning Window, allowing tuning of the
ADF , ADF Mode selection, ADF volume control, and selection of
the DME
Displays transponder mode selection softkeys
Selects the #1 transponder as active
Selects the #2 transponder as active
Selects standby mode (transponder does not reply to any
interrogations)
Selects Mode A (transponder replies to interrogations)
Selects Mode C – altitude reporting mode (transponder replies to
identification and altitude interrogations)
Manually selects Ground Mode, the transponder does not allow
Mode A and Mode C replies, but it does permit acquisition
squitter and replies to discretely addressed Mode S interrogations
Automatically enters the VFR code (1200 in the U.S.A. only)
Displays transponder code selection softkeys 0-7
Use numbers to enter code
0 — 7
BKSP Removes numbers entered, one at a time
Activates the Special Position Identification (SPI) pulse for 18
seconds, identifying the transponder return on the ATC screen
Displays Timer/References Window
Displays Nearest Airports Window
Displays Messages Window
Garmin G1000 Pilot's Guide for the Socata TBM 850/900
Description
190-00709-05 Rev. D