Garmin G1000 Manual page 60

SYSTEM OVERVIEW
cDi/BaRO s
ynchROnizatiOn
See the Flight Instruments section for a discussion on synchronizing both PFD' s Course Deviation
Indicators and the altimeter barometric settings.
P P
ilOt ROFiles
System settings may be saved under a pilot profile. When the system is powered on, the last selected
pilot profile is shown on the MFD power-up screen (Figure 1-8). The G1000 can store up to 25 profiles;
the currently active profile, the amount of memory used, and the amount of memory available are shown at
the top of the System Setup Page in the box labeled 'Pilot Profile'. From here, pilot profiles may be created,
selected, renamed, or deleted.
Creating a profile:
1) Use the FMS Knob to select the AUX - System Setup Page.
2) Press the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight 'CREATE' in the Pilot Profile Box.
4) Press the ENT Key. A 'Create Profile' window is displayed.
5) Use the FMS Knob to enter a profile name up to 16 characters long and press the ENT Key. Pilot profile names
cannot begin with a blank as the first letter.
6) In the next field, use the small FMS Knob to select the desired settings upon which to base the new profile.
Profiles can be created based on Garmin factory defaults, default profile settings (initially based on Garmin
factory defaults unless edited by the pilot), or current system settings.
7) Press the ENT Key.
46
Figure 1-34 Pilot Profiles (System Setup Page)
Garmin G1000 Pilot's Guide for the Socata TBM 850/900 190-00709-05 Rev. D