Example Flight Plan; Departure - Garmin G1000 Manual

AUTOMATIC FLIGHT CONTROL SYSTEM

7.6 EXAMPLE FLIGHT PLAN

The following example flight plan and diagrams (not to be used for navigation) in this section are
NOTE:
for instructional purposes only and should be considered not current. Numbered portions of accompanying
diagrams correspond to numbered procedure steps.
This scenario-based set of procedures (based on the example flight plan found in the Flight Management
Section) shows various Garmin AFCS modes used during a flight. In this scenario, the aircraft departs Charles B.
Wheeler Downtown Airport (KMKC), enroute to Colorado Springs Airport (KCOS). After departure, the aircraft
climbs to 12,000 ft and airway V4 is intercepted, following ATC vectors.
Airway V4 is flown to Salina VOR (SLN) using VOR navigation, then airway V244 is flown using a GPS flight
plan. The ILS approach for runway 35L and LPV (WAAS) approach for runway 35R are shown and a missed
approach is executed.
KCOS

DEPARTURE

Climbing to the Selected Altitude and flying an assigned heading:
1) Before takeoff:
a) Use the ALT SEL Knob to set the Selected Altitude to 12,000 feet.
b) Push the GA Switch to activate Takeoff Mode. The flight director Command Bars establish a pitch up attitude
to follow.
c) Press the AP Key to engage the autopilot in a climb, holding the pitch angle commanded in Takeoff Mode and
wings level.
532
Figure 7-35 Flight Plan Overview
Garmin G1000 Pilot's Guide for the Socata TBM 850/900
KMKC
190-00709-05 Rev. D