Garmin G1000 Manual page 479

PROFILE PATH
The Profile Path displays the horizontal and lateral boundaries of the Profile View. The path is shown as a
white rectangle on the Navigation Map Page and is only available when Profile View is enabled. White range
markers both edges of the Profile Path rectangle match the range markers along the distance scale inside the
Profile View display window whenever the profile range is at least 4 nm (or 7.5 km if configured for metric
units).
The Profile Path rectangle may be configured on or off, and the Navigation Map range at which the Profile
Path is removed from map display can be changed.
Customizing the Profile Path display on the Navigation Map Page:
1) Select the Navigation Map Page.
2) Press the MENU Key.
3) With 'Map Setup' highlighted, press the ENT Key (Figure 6-160).
4) Turn the small FMS Knob to select the 'Profile' Group and press the ENT Key (Figure 6-161).
5) Turn the large FMS Knob or press the ENT Key to scroll through product selections (Figure 6-162).
• PROFILE PATH – Turns the display of the Profile Path on or off and sets maximum range at which Profile Path
is shown
6) Turn the small FMS Knob to scroll through options (ON/OFF, range settings).
7) Press the ENT Key to select an option.
8) Press the FMS Knob or CLR Key to return to the Navigation Map Page with the changed settings.
190-00709-05 Rev. D Garmin G1000 Pilot's Guide for the Socata TBM 850/900
Flight Phase Total Profile View Width
Approach 0.6 nm
Departure 0.6 nm
Terminal 2.0 nm
Enroute 4.0 nm
Oceanic 4.0 nm
Table 6-26 Profile View Width Scale
HAZARD AVOIDANCE
465