Garmin G1000 Manual page 527

The Airspeed Reference (shown in both the AFCS Status Box and above the Airspeed Indicator) may be
adjusted by:
• Using the NOSE UP/DN Wheel
• Pressing the CWS Button, hand-flying the aircraft to attain a new Airspeed Reference, then releasing the CWS
Button
If the Selected Altitude is reached during CWS maneuvering, the Altitude Reference is not changed.
NOTE:
To adjust the Altitude Reference in this case, the CWS Button must be pressed again after the Selected
Altitude is reached.
Airspeed Reference units can be manually toggled between IAS and Mach units using the SPD Key. When
the FLC Airspeed Reference is displayed in Mach, the Airspeed Reference Bug is displayed on the Airspeed
Indicator at the IAS corresponding to the selected Mach target speed and the current Mach number is shown
below the Airspeed Indicator.
Airspeed
Reference
Airspeed
Reference
Bug
Current
Mach
Number
190-00709-05 Rev. D
Flight Level
Change Mode
Active
Command Bars Indicate Climb
to Attain Selected Altitude
Figure 7-11 Flight Level Change Mode (Mach)
Garmin G1000 Pilot's Guide for the Socata TBM 850/900
AUTOMATIC FLIGHT CONTROL SYSTEM
Airspeed Selected
Reference Altitude Capture
(Mach) Mode Armed
513