Garmin G1000 Manual page 398

HAZARD AVOIDANCE
Cancelling a Connext Data Request in Progress:
1) Select the Weather Data Link (CNXT) Page.
2) Press the MENU Key.
3) With 'Connext Data Request' highlighted, press the ENT Key.
4) Turn the large FMS Knob to select 'CANCEL REQ' and press the ENT Key. The request status box indicates
'Request Cancelled'.
5) Press the FMS Knob to return to the Weather Data Link (CNXT) Page.
The pilot can schedule Connext Data Requests to recur automatically. Auto requests remain enabled until
the pilot disables them, or the system power is cycled. The Request Status Window will indicate a countdown
timer until the next automatic data request occurs.
If automatic Connext Data Requests were enabled prior to the system entering Reversionary Mode,
NOTE:
the automatic weather data requests will continue in Reversionary Mode, however the Connext Data
Request menu and its associated options will not be available.
Enabling/disabling automatic Connext Data Requests:
1) Select the Weather Data Link (CNXT) Page.
2) Press the MENU Key.
3) With 'Connext Data Request' highlighted, press the ENT Key.
4) Choose the desired weather coverage options.
5) Turn the large FMS Knob to select the 'UPDATE RATE' setting. Then turn the small FMS Knob to highlight the
desired automatic update frequency (Off, 5 Min, 10 Min, 15 Min, 20 Min, 30 Min, 45 Min, or 60 Min), then press
the ENT Key.
6) The 'SEND REQ" button is highlighted and a countdown timer is displayed in the 'REQUEST STATUS' based
on the currently selected update rate. Press the ENT Key to immediately send an immediate Connext Data
Request.
Or :
Press the FMS Knob to return to the Weather Data Link (CNXT) Page.
384 Garmin G1000 Pilot's Guide for the Socata TBM 850/900 190-00709-05 Rev. D