Garmin G1000 Manual page 684

APPENDIX A
MISCELLANEOUS MESSAGE ADVISORIES (CONT.)
Message
VNV – Unavailable. Excessive track
angle error.
VNV – Unavailable. Excessive
crosstrack error.
VNV – Unavailable. Parallel course
selected.
TRAFFIC FAIL – Traffic device has
failed.
NON WGS84 WPT – Do not use GPS
for navigation to [xxxx]
STRMSCP FAIL – Stormscope has
failed.
FAILED PATH – A data path has failed. A data path connected to the GDU or the GIA 63/W has failed.
MAG VAR WARN – Large magnetic
variance. Verify all course angles.
SVT – SVT DISABLED: Out of available
terrain region.
SVT – SVT DISABLED: Terrain DB
resolution too low.
SCHEDULER [#] – <message>.
CHECK CRS – Database course for
LOC1 / [LOC ID] is [CRS]°.
CHECK CRS – Database course for
LOC2 / [LOC ID] is [CRS]°.
[PFD1, PFD2, or MFD1] CARD 1 REM
– Card 1 was removed. Reinsert card.
[PFD1, PFD2, or MFD1] CARD 2 REM
– Card 2 was removed. Reinsert card.
[PFD1, PFD2, or MFD1] CARD 1 ERR
– Card 1 is invalid.
[PFD1, PFD2, or MFD1] CARD 2 ERR
– Card 2 is invalid.
ECS – Service required.
EPS – Service required.
EPS – S/G speed sensor failed.
CRUISE I – Cruise I conditions met.
670
Comments
The current track angle error exceeds the limit, causing the vertical deviation to go
invalid.
The current crosstrack exceeds the limit, causing vertical deviation to go invalid.
A parallel course has been selected, causing the vertical deviation to go invalid.
The G1000 is no longer receiving data from the traffic system. The traffic device
should be serviced.
The position of the selected waypoint [xxxx] is not calculated based on the WGS84
map reference datum and may be positioned in error as displayed. Do not use GPS to
navigate to the selected non-WGS84 waypoint.
Stormscope has failed. The G1000 system should be serviced.
The GDU's internal model cannot determine the exact magnetic variance for
geographic locations near the magnetic poles. Displayed magnetic course angles may
differ from the actual magnetic heading by more than 2°.
Synthetic Vision is disabled because the aircraft is not within the boundaries of the
installed terrain database.
Synthetic Vision is disabled because a terrain database of sufficient resolution (9 arc-
second or better) is not currently installed.
Message criteria entered by the user.
Selected course for LOC1 differs from published localizer course by more than 10
degrees.
Selected course for LOC2 differs from published localizer course by more than 10
degrees.
The SD card was removed from the top card slot of the PFD or MFD. The SD card
needs to be reinserted.
The SD card was removed from the bottom card slot of the PFD or MFD. The SD card
needs to be reinserted.
The SD card in the top card slot of the PFD or MFD contains invalid data.
The SD card in the bottom card slot of the PFD or MFD contains invalid data.
The Environmental Control System has failed.
Electrical Power System needs servicing.
Starter Generator speed sensor has failed.
Cruise I engine trend data log has been captured.
Garmin G1000 Pilot's Guide for the Socata TBM 850/900 190-00709-05 Rev. D