Garmin G1000 Manual page 230

FLIGHT MANAGEMENT
6) If desired, change the storage method of the waypoint to "TEMPORARY" or "NORMAL" by moving the cursor
to "TEMPORARY" and selecting the ENT Key to check or uncheck the box.
7) Press the FMS Knob to remove the flashing cursor.
Or :
1) Press the FMS Knob to activate the cursor.
2) Enter a user waypoint name (up to six characters).
3) Press the ENT Key. The message 'Are you sure you want to create the new User Waypoint AAAAAA?' is
displayed.
4) With 'YES' highlighted, press the ENT Key.
5) If desired, define the type and location of the waypoint in one of the following ways:
a) Select "RAD/RAD" using the small FMS Knob, press the ENT Key, and enter the two reference waypoint
identifiers and radials into the REFERENCE WAYPOINTS window using the FMS Knobs.
Or :
b) Select "RAD/DIS" using the small FMS Knob, press the ENT Key, and enter the reference waypoint identifier,
the radial, and the distance into the REFERENCE WAYPOINTS window using the FMS Knobs.
Or :
c) Select "LAT/LON" using the small FMS Knob, press the ENT Key, and enter the latitude and longitude into
the INFORMATION window using the FMS Knobs.
6) Press the ENT Key to accept the new waypoint.
7) If desired, change the storage method of the waypoint to "TEMPORARY" or "NORMAL" by moving the cursor
to "TEMPORARY" and selecting the ENT Key to check or uncheck the box.
8) Press the FMS Knob to remove the flashing cursor.
216
Figure 5-47 User Waypoint Information Page Menu
Garmin G1000 Pilot's Guide for the Socata TBM 850/900 190-00709-05 Rev. D