Shunt Connector Cn15; Shunt Connector Cn15 Location; Shunt Connector Cn15 Configuration Options - YASKAWA P7 User Manual

!

Shunt Connector CN15

The shunt connector CN15 is described in this section. Shunt connector along with parameters H4-07 and H4-08 select the
signal range of the analog output terminals FM and AM.
Shunt connector CN15 is only available when the optional Terminal Card with the 4-20mA Analog Output Monitor is installed
(Model No. ETC61812_). See Chapter 7, Maintenance, for installation of the optional Terminal Card.
The function of various shunt connector CN15 configurations is shown in Table 2.13.
The software configuration for the analog output monitor signal type is listed below:
Parameter
Parameter Name
No.
Digital Operator Display
Terminal FM Signal Level
H4-07 Selection
AO Level Select1
Terminal AM Signal Level
H4-08 Selection
AO Level Select2
Fig 2.11 Shunt Connector CN15 Location
Table 2.13 Shunt Connector CN15 Configuration Options
CN15
Voltage Output (0-10Vdc) for terminals FM-AC (CH1) and AM-AC (CH2)
Current Output (4-20mA) for terminals FM-AC (CH1) and AM-AC (CH2)
Voltage Output (0-10Vdc) for terminals FM-AC (CH1)
Current Output (4-20mA) for terminals AM-AC (CH2)
Current Output (4-20mA) for terminals FM-AC (CH1)
Voltage Output (0-10Vdc) for terminals AM-AC (CH2)
0: 0 - 10 V
2: 4-20 mA
0: 0 - 10 V
2: 4-20 mA
Electrical Installation 2 - 25
Analog Output Monitor Configurations
Description
Setting Factory Menu
Range Setting Location
0 or 2 0 Programming
0 or 2 0 Programming