Motor Setup; Com Opt Setup - YASKAWA P7 User Manual

Parameter
Parameter Name
No.
Digital Operator Display
Motor Rated Current
E2-01
Motor Rated FLA
E2-03 No-Load Current
Motor Line-to-Line
E2-05 Resistance
Term Resistance
Operation Selection after
F6-01 Communication Error
Comm Bus Flt Sel
Detection Selection of
External Fault from
F6-02
Communication Option Card
EF0 Detection
Stopping Method for
External Fault from
F6-03
Communication Option Card
EF0 Fault Action
Current Monitor Display Unit
F6-05 Selection
Current Unit Sel
Table 1: Parameter List (Continued)
Description

Motor Setup

Set to the motor nameplate full load amps.
Sets the magnetizing current of the motor.
Phase to phase motor resistance, normally set by the autotuning
routine.

Com OPT Setup

Sets the stopping method for option PCB communications error
(BUS fault). Active only when a communications option PCB is
installed and when b1-01 or b1-02 = 3.
0: Ramp to Stop
1: Coast to Stop
2: Fast-Stop
3: Alarm Only
0: Always detected
1: Detected only during operation
0: Ramp to Stop
1: Coast to Stop
2: Fast-Stop
3: Alarm Only
0: A Display (Amps)
1: 100%/8192 (Drive Rated Current)
Parameters A - 11
Setting Factory Menu
Range Setting Location
10% to
kVA
200% kVA Quick Setting
Dependent
Dependent
kVA kVA
Programming
Dependent Dependent
0.000 to kVA
Programming
65.000 Dependent
0 to 3 1 Quick Setting
0 or 1 0 Programming
0 to 3 1 Programming
0 or 1 0 Programming