Digital Operator Keys - YASKAWA P7 User Manual

Digital Operator Keys

The names and functions of the Digital Operator Keys are described in Table 3.1.
Key
Table 3.1 Digital Operator Keys
Name
• Switches between operation via the Digital Operator (LOCAL) and the settings in
parameter b1-01 (Frequency Reference Selection) and b1-02 (Run Command
Selection) (REMOTE).
LOCAL / REMOTE
• This key can be enabled or disabled by the setting in parameter o2-01.
• The Drive must be in a stopped condition before it can be transferred to "LOCAL"
or "REMOTE" mode.
•
MENU
•
•
ESCAPE
•
JOG
Selects the rotation direction of the motor when the Drive is being operated
•
FWD / REV
from the Digital Operator (LOCAL).
•
INCREASE
•
•
DECREASE
•
•
SHIFT/RESET
•
DATA/ENTER •
• Starts Drive operation when the Drive is being controlled by the Digital Operator
RUN
(LOCAL).
•
STOP Key
• This key can be enabled or disabled when operating from the external
terminal or communications by setting user parameter o2-02.
Scrolls through the five main menus:
Operation (-DRIVE-), Quick Setting (-QUICK-), Programming (-ADV-),
Modified Constants (-VERIFY-), and Auto-Tuning (-A.TUNE-).
Returns to the previous display, before the DATA/ENTER key was
pressed.
Enables jog operation when the Drive is being operated from the Digital
Operator (LOCAL).
Increases parameter numbers and set values.
Used to move to the next item or data value.
Decreases parameter numbers and set values.
Used to move to the previous item or data value.
Selects the digit to be changed. The selected digit will blink.
Also resets the Drive when a fault has occurred. The run command must be
removed before the reset command will be accepted.
Enter menus and parameters as well as to set values.
Stops Drive operation.
Digital Operator 3 - 3
Function