Removing/Attaching The Digital Operator And Front Cover; Removing The Front Cover; Attaching The Front Cover - YASKAWA P7 User Manual

Removing/Attaching the Digital Operator and Front Cover

!
Models CIMR-P7U20P4 thru 2018 (0.5HP to 25HP @ 208V/240V) and 40P4 thru
4018 (0.5HP to 30HP @ 480V)
For Models CIMR-P7U2018/4018 and smaller, remove the terminal cover and then use the following procedures to remove
the Digital Operator and front cover.
#Removing the Digital Operator
Press on the side of the Digital Operator in the direction of arrow 1 to unlock, then lift the Digital Operator in the direction of
arrow 2 to remove it as shown in Fig 1.11.

#Removing the Front Cover

Press the left and right sides of the front cover in the direction of arrows 1 and lift the bottom of cover in the direction of arrow
2 to remove it as shown in Fig 1.12.

#Attaching the Front Cover

Mount the front cover to the Drive by performing the steps to remove the front cover in reverse order.
1. Do not mount the front cover with the Digital Operator attached to the front cover; this may cause the Digital Operator to
malfunction due to imperfect contact.
2. Insert the tab of the upper part of the front cover into the groove of the Drive and press the lower part of the front cover onto
the Drive until the front cover snaps into place.
2
1
Fig 1.11 Removing the Digital Operator
1
2
Fig 1.12 Removing the Front Cover
Physical Installation 1 - 16