Tms Report - Ingenico IWL200 series User Manual

Terminal User Guide

TMS Report

Approximately once a month your terminal will call the Terminal
Management System (TMS) to receive any updates to the software,
details of new card schemes, and any changes to your configuration.
This call will take place automatically, normally outside of standard
trading hours.
After the TMS call has taken place your terminal will print a TMS report,
indicating if the communication was successful or has failed.
If the TMS call is interrupted part way through downloading a new or
updated configuration file, for example due to a communications
problem, the terminal will be set into a
usable until the file has been downloaded.
If your terminal displays the
terminal is not initialised. Press menu once, and choose the
menu option. You should contact the terminal Helpdesk if the problem
persists after a successful TMS call.
Example successful TMS report
Terminal ID
Print Date & Time
The status of
TMS), or
The status of
FAIL
(if download was not successful), or
was required).
TMS CALL
Merchant Name
Merchant Address 1
Merchant Address 2
TID:22160001
S/N:01234WL12345678
02/01/11 02:36
CONNECTED:
CONIG DATA:
REPORT COMPLETE
CONNECTED
FAIL
(if unable to connect to the TMS).
CONFIG DATA
NOT READY
NOT READY
OK
OK
OK
may be; (if successfully connected to the
OK
may be; (if download was successful),
state, and will not be
status message then your
Serial Number
Result
NOT REQUIRED
(if no update
Reports
SETUP
77