Removing A Wi-Fi Connection Profile; Loading A Paper Roll - Ingenico IWL200 series User Manual

Terminal User Guide

Removing a Wi-Fi Connection Profile

If you need to delete a saved Wi-Fi connection profile you should select
REMOVE PROFILE
Remove Profile:
Network_1
Network_2
You will receive a confirmation that the Wi-Fi connection profile has
been deleted.

Loading a Paper Roll

Your terminal is supplied with one paper roll already installed. When the
paper roll is nearing the end a red line will appear on the paper, this
indicates that the paper roll must be replaced.
To replace the paper roll:
Fig. 1a
1. Hold your terminal securely in one hand, with the other hand, and
by using two fingers; lift the printer cover release as shown. Fully
open the printer cover and remove the old roll of paper.
2. Unstick the end of the new roll, leaving the end free; carefully place
the paper roll into the printer compartment.
3. Holding the free end of the paper and your terminal, close the
printer cover carefully and push firmly until it locks.
4. While your terminal is displaying the idle screen, press and hold the
clear key to ensure that the paper feeds correctly.
.
0000
Fig. 1b
You should only use approved paper rolls as supplied by your
terminal supplier. Only thermal paper rolls that are 57mm wide
and 40mm in diameter can be used in your terminal; attempting
to fit rolls of a different size may damage your terminal.
Use the up and down keys to select the Wi-
Fi connection profile that you wish to delete
and press the enter key.
Fig. 2
Your Terminal
Fig. 3
21