Balance Report - Ingenico IWL200 series User Manual

Reports
X Balance Report
The X Balance report is sometimes referred to as an End of Shift
Balance report. This is because it allows you to print a total of all
transactions performed since the last Z Balance report. The X Balance
may be printed at any time throughout the day.
Transactions are listed by card type, and by Operator ID (Waiter ID for
example, if enabled) showing transactions together with any gratuities
or cashback (if enabled) by each operator.
A list of all transactions done since the last Z Balance was completed is
also shown.
To perform an X Balance report press the menu key twice, then choose
REPORTS
supervisor password, then press enter, choose
the F3 key.
 MENU, MENU, F1, [password], ENTER, F3
The X Balance report is exactly the same as the Z Balance excepting
the totals are not reset.
Example X Balance report
Please refer to the following section entitled Z Balance Report for more
details on the contents of the X Balances report.
72
The totals within the terminal will not be reset after printing an X
Balance.
by pressing the F1 key. You will be asked to type your
X BALANCES
Totals Not Reset
Merchant Name
Merchant Address 1
Merchant Address 2
Terminal User Guide
X BALANCE
by pressing