Tms Report - Ingenico iCT220 User Manual

Reports

TMS Report

Approximately once a month your terminal will call the
Terminal Management System (TMS) to receive any updates to
the software, details of new card schemes, and any changes to
your configuration. This call will take place automatically,
normally outside of standard trading hours.
After the TMS call has taken place your terminal will print a
TMS report, indicating if the communication was successful or
has failed.
If the TMS call is interrupted part way through downloading a
new or updated configuration file, for example due to a
communications problem, the terminal will set it into a NOT
READY state, and will not be usable until the file has been
downloaded.
If your terminal displays the NOT READY status message then
your terminal is not initialised. Press menu once, and choose
the SETUP menu option. You should contact the terminal
Helpdesk if the problem persists after a successful TMS call.
Example successful TMS report
Serial Number
The status of CONNECTED may be; OK (if successfully connected
to the TMS), or FAIL (if unable to connect to the TMS).
The status of CONFIG DATA may be; OK (if download was
successful), FAIL (if download was not successful), or NOT
REQUIRED (if no update was required).
68
TMS CALL
Merchant Name
Merchant Address 1
Merchant Address 2
TID:22160001
S/N:01234PT12345678
02/01/08 02:36
CONNECTED:
CONFIG DATA:
REPORT COMPLETE
Terminal User Guide
Print Date & Time
OK
OK
Terminal ID
Result