Ingenico iWL300 Series Quick Start Manual

Quick Start Guide
DOCUMENT D'EXECUTION
INGENICO_TD.ai
INFORMATIONS GENERALES COULEURS UTILISEES APPROBATION
Client: INGENICO
iWL200 Series
Date : 10 DEC 2013
7540 C 1795 C
Utilisation: Impression en tons
directs.
Ne pas utiliser pour application
écran.

GETTING STARTED

Set up the base unit in a convenient location close to a
power source and a telephone socket and/or an Ethernet
(Broadband) socket.
To connect the base unit to a telephone point, remove
the base cover by releasing the clips shown in the
diagram. Connect one
Cable to the telephone socket on the base unit (marked
MODEM), the other end should be plugged into an
analogue telephone line (BT) socket. To connect the Ethernet
Cable, connect one end to the Ethernet Socket on the back
of the base, the other to either a router or wall mounted
Ethernet socket. Note: GPRS terminals do not have any
cables.
Finally, connect the Power Supply Unit into the power socket on the base unit and to the mains
power. Place the Handset onto the base. After a short initialisation process the terminal will display
the READY prompt and is ready to use.
Note: If you connect both the Telephone and Ethernet cables, the Ethernet connection will be
used in preference. The Telephone connection may be used as a backup. Connecting the terminal
to a phone line serving any call barring, waiting or alarm features is not recommended.
SUPERVISOR PASSWORD
The default Supervisor Password is 0000. Note: You will be prompted to change this.

FUNCTION KEYS

F1-F4 Keys: Function keys which enable scrolling up and down menus.
Menu Key: To enter the application menus press the Menu key from
the READY prompt. Pressing the key again moves to the next menu
(if available).
Correction Keys: When entering numbers or letters, the yellow CLEAR
key deletes one character at a time, whilst the red CANCEL key deletes
the entire line (this key also cancels transactions).
Confirmation Key: The green ENTER key is used to confirm anything
that has been typed into the terminal.
Paper Feed Key: To test the feeding of the paper through the printer,
press and hold the CLEAR key.
THE CHIP CARD READER
Customer cards must be inserted with the chip upwards. Push the card fully into the slot below the
keypad and follow the instructions on screen. DO NOT remove the card until instructed to do so by
the terminal.
If you see a BAD READ message, check the card orientation and try again. After three bad reads
the terminal may prompt you to swipe the card.
Please refer to the brochure enclosed with your terminal for important safety information regarding the equipment and its use,
and to the terminal User Guide which you can find online at www.ingenico.co.uk for other relevant compliance information.
end of the UK Telephone
(if configured)
Connecting the Base Unit
Base
Cover
Release
Clips
Telephone
Socket
(Modem)
Ethernet
Socket
Power
Socket