Fitting The Faston Connector To The Human Interface - Rotax 912 i Series Installation Manual

5.1) Fitting the Faston connector to the Human Interface Connector
See
General note
NOTE:
The following special tools and equipment are necessary for fitting the
Special tools
Faston connector.
n.a.
n.a.
Fitting the Faston connector
Procedure
Step
1
2
3
4
5
NOTE:
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
INSTALLATION MANUAL
Fig. 11.
Faston connectors (1) are supplied loose. The Faston con-
nectors and connector receptacles for the airframe are in-
cluded in the scope of delivery.
Part number
MOLEX Crimping pliers 64016-0035
MOLEX Disassembly tool 63813-1500
Strip cable (2) as required (A).
Use suitable crimping pliers (3) to fit the Faston connector (B).
Push the Faston connector in the corresponding slot (4) of the Human Interface
Connector receptacle until it is locked in place (C).
Check for tight fit.
Press the pin holder (white) downwards using the long nose pliers.
The pin holder must not be pressed with excessive force.
Description
Procedure
24-00-00
Page 18
January 01/2012